By federal rule, mostly no. FDA's preventive controls rule, the one that makes food makers write a hazard analysis, exempts alcoholic beverages made at a facility that holds its federal alcohol permit and is registered with FDA. What still applies is good manufacturing practice: a clean, sound plant, safe water, equipment that doesn't contaminate the product. And your alcohol regulator has requirements of its own. But "exempt from writing a plan" isn't "free of hazards". A distillery has a short list of real ones: what comes over first in a run, metals from the still and its fittings, glass at bottling, and allergens in liqueurs and flavored spirits. A buyer may ask for a plan regardless. Three control points on a page answer the buyer and are worth having. Below are the exemption, the hazards, and a worksheet.
The short version
- Alcoholic beverages at a permitted, registered distillery: no hazard analysis required by FDA's rule.
- Good manufacturing practice still applies.
- Anything non-alcoholic you make and sell (shrubs, mixers) may not be covered by the exemption.
- Control the first part of each run, by a written rule.
- Food-grade materials only where hot vapor and spirit touch.
- Cream and nut liqueurs: an allergen label check on every run.
The exemption
| Product | FDA hazard analysis and preventive controls |
|---|---|
| Whiskey, gin, vodka, brandy, liqueurs, at a permitted and registered distillery | Don't apply |
| Non-alcohol food made at the same place, prepackaged, and no more than 5% of sales | Don't apply |
| Other non-alcohol food: bottled mixers, bitters sold as food, sauces from the tasting room kitchen | May well apply: ask |
The exemption is from the plan-writing parts of the rule. The good manufacturing practice part isn't waived. What that part asks is laid out as a checklist in GMP checklist. A brewery's version of the same question is in brewery HACCP plan.
The hazards
The first part of the run. Fermentation makes small amounts of methanol and other volatile compounds along with ethanol, more from fruit than from grain. Distilling concentrates what the wash contains, and the early part of a spirit run is where distillers separate what they don't want. Every distillery has a rule for foreshots and for the heads cut. The control is that the rule is written down and followed on every run, by whoever is at the still, including the new hire. For fruit spirits, a lab test for methanol on each new product settles it with a number. Limits for spirits are your alcohol regulator's to state: ask them.
Metals. Hot, acidic alcohol vapor dissolves a little of what it touches. Lead from old solder, brass fittings not meant for spirits, and the wrong hoses are the usual sources. New commercial stills are built for this; secondhand and homemade equipment may not be. Keep the materials list for everything on the vapor and spirit side, and test a new still's output once.
Botanicals. Gin, bitters and infusions use plants, and not every plant is permitted in food. Check each botanical before it goes in a recipe, and buy from suppliers who can document what they sell.
Glass and particles. New bottles arrive with dust and the occasional chip; barrel char and filter fibers can carry through. Rinse and inspect every bottle, and check the final filter at the start and end of each bottling run.
Allergens. Plain spirits are simple. A cream liqueur contains milk. A nut liqueur made with real nuts contains tree nuts. Egg-based liqueurs exist. When one of those runs on the bottling line before a plain spirit, the line needs a full clean, and the labels need checking: how allergens appear on an alcohol label is your alcohol regulator's rule.
Three control points
A made-up craft distillery. Its rules are its own.
| CCP | This distillery's rule | Checked | If it's missed |
|---|---|---|---|
| 1 Cuts | The first 500 mL of each 50 gallon spirit run discarded; heads cut by the written procedure; each new fruit spirit lab-tested | Volume written on the run sheet | The run is redistilled |
| 2 Glass and filtration | Every bottle rinsed and inspected; final filter intact | Each bottling run, start and end | Refilter everything since the last good check |
| 3 Allergen label | Cream and nut liqueurs carry their allergens as approved; no plain spirit after them without a full clean | First and last bottle of each run | Hold and relabel |
On the worksheet's log, a new distiller collected the foreshots into the heads jar on run 116. The heads from that run were set aside and redistilled, and the foreshots step became a signed line on the run sheet. That's what a written rule is for.
What a buyer wants
A grocery chain's form says "attach HACCP plan" because its form is written for food. Send three things: a short statement that the distillery is a permitted, FDA-registered alcohol producer and that the preventive controls requirements don't apply to its alcoholic beverages; your one-page plan with these control points; and your recall procedure. Most buyers accept that. A recall procedure for a drinks maker is in recall plan for a brewery, and each run's record in distilling log sheet.
This is general information, not legal advice. Your alcohol regulator and FDA have the last word, and state rules vary. The business is in distillery business plan.
Get the worksheet
Download the distillery food safety worksheet. Three sheets and a read-me: the hazard analysis from grain to bottle, the plan with its three control points, and a log. Replace the example's rules with your own. It's an ordinary Excel file with no macros, and it works in Google Sheets, LibreOffice and Numbers.
Where this stops working
A customer reports a chip of glass in a bottle of gin. Which bottling run? The bottle has a lot code, if someone set the coder that day. The bottling log is on a clipboard. Which glass delivery was on the line, and which other spirits were bottled from the same pallet of glass, is on nobody's sheet.
How TaroStack does it
TaroStack ties the bottle to its run, its spirit and its glass.
Each bottling run is a batch with a lot code. Recording it takes the spirit, bottles, closures and labels from stock and notes which lots were consumed, automatically: the pallet of glass is on the record.
Each distilling run is a batch too, so a bottle traces back through blending to the runs and the grain.
Your checks are fields on the batch record: foreshots volume, filter intact, label checked, initials, a sign-off.
Allergens on Growth. With allergen tracking on, a batch can't start if its label leaves out an allergen its ingredients contain.
One report for a recall: every bottling run that used a lot of glass, and which accounts received those cases.
| The question | Clipboards | In TaroStack |
|---|---|---|
| Which run a bottle came from | The code, if it was set | The lot |
| Which glass was on the line | Unknown | On the batch record |
| Other runs from that pallet | Unknown | Every batch that used the lot |
| Who has those cases | Invoices | One report |
TaroStack doesn't file TTB reports or test spirits. Recipes, batches, lots and recalls are on every plan, from $9.99 a month (5 recipes) or $39 a month (50 recipes, with allergen tracking). The first 14 days are free, with no credit card. If you'd like a hand setting up, ask, and we'll do it with you.
