Skip to content

HACCP Plan for Yogurt: Pasteurize, pH 4.6, Label

A HACCP plan for yogurt: pasteurize before the culture goes in, reach pH 4.6, label the allergens. The federal limits, a monitoring log and a worksheet.

By Koa Sterling. Product specialist at TaroStack and small business owner. Yes, I am a real human, and I actually sit in front of a computer and write these articles. Reviewed November 20, 2026 · 7 min read

A yogurt plan turns on three points. Pasteurize the milk before the culture goes in: the federal definition is every particle held at 145°F for 30 minutes or 161°F for 15 seconds, and 5°F hotter if the mix is sweetened or is 10% fat or more. Get the acid up: the yogurt standard sets a pH of 4.6 or lower, measured within 24 hours after filling. And put the right label on the cup, because milk is an allergen and one flavor may add another. Everything after the pasteurizer (fruit, the filling room, the cooler) is kept safe by cleaning and by suppliers' paperwork, not by a critical limit. A maker selling to shops generally needs this in writing: FDA calls it a food safety plan, and most people still call it HACCP. Below are the limits, a few days of readings, and a worksheet.

The short version

  • Pasteurize first: 145°F for 30 minutes at least, 150°F if sugar is already in.
  • Ferment to pH 4.6 or lower. Set your own time limit for getting there.
  • Fruit goes in after the heat step, so it has to arrive safe: get the supplier's paper.
  • The filling room is where Listeria gets in. Clean it like it matters.
  • Check the label on the first and last cup of every run.
  • TaroStack keeps each vat as a batch, with its readings and the lots that went in. More below.

The three points

CCP Limit Where it comes from Checked If it's missed
1 Pasteurization 145°F for 30 minutes; 150°F if sweetened or 10% fat or more 21 CFR 131.3(b) Recording chart; thermometer at the start and end of the hold Reheat and hold the full time again
2 Fermentation pH 4.6 or lower 21 CFR 131.200 pH meter, each vat Batch on hold, not shipped
3 Labeling Each cup carries its own flavor's label Allergen labeling law First and last cup of each run Hold and relabel

Pasteurization

The legal table for dairy products:

Temperature Time
145°F 30 minutes
161°F 15 seconds
191°F 1 second

Add 5°F to each when the product is 10% fat or more or contains added sweeteners. So a vanilla mix with the sugar already in is held at 150°F, not 145°F.

Yogurt makers usually go far past the minimum, to 180°F or more for half an hour, because a hotter, longer hold makes a thicker yogurt. That's a recipe choice. The made-up creamery in the worksheet runs 185°F for 30 minutes and writes both numbers on its plan: the legal limit, and its own process. If a vat only reaches 170°F, it has met the law and missed the recipe, and the plan should make clear which one a reading failed.

"Every particle" is the hard part in a vat. Foam and the milk on the lid are cooler than the milk at the thermometer. Your state's dairy regulator licenses the plant and has its own requirements for the pasteurizer and its thermometers. Ask before you buy equipment.

Fermentation

Warm, pasteurized milk with a culture in it is safe because the culture wins: it makes acid faster than anything else can grow. The standard's number is pH 4.6 or lower. What the standard doesn't give is how long you have, so the plan needs your own limit. This creamery's is eight hours from adding culture. A vat that isn't at 4.6 by then goes on hold, because a slow ferment means something was wrong (a tired culture, a cold incubator, a residue in the milk) and warm milk sat for hours without its protection.

Calibrate the meter every day with pH 4 and pH 7 buffers, and write that down too. A reading from a meter nobody calibrated isn't a record.

After the heat step

Nothing after the pasteurizer kills anything, so three things matter.

Fruit and flavors. A fruit preparation stirred into finished yogurt has to be safe when it arrives. Keep each lot's certificate from the supplier showing it was heat treated, with an allergen statement.

The room. Listeria lives in cold, wet places: drains, floor seams, the underside of a filler. Controlling it is cleaning, sanitizing and swabbing on a schedule, set out in environmental monitoring program template and sanitation SOP template.

The cold. At pH 4.6 or lower, cold storage is mostly about shelf life, which is covered in yogurt shelf life.

A few days of readings

When Batch Check Reading Limit OK?
Nov 16, 7:10 AM YG-1116 plain Pasteurization, start of hold 186°F 145°F or above Yes
Nov 16, 7:40 AM YG-1116 plain Pasteurization, end of hold 185°F 145°F or above Yes
Nov 16, 1:05 PM YG-1116 plain pH, hour 5 4.52 4.6 or lower Yes
Nov 17, 7:15 AM YG-1117 vanilla, sweetened Pasteurization, start of hold 186°F 150°F or above Yes
Nov 17, 4:10 PM YG-1117 vanilla, sweetened pH, hour 8 4.78 4.6 or lower NO: act

On the 17th the vanilla vat was at 4.78 after eight hours. It went on hold. The incubator was found at 98°F, ten degrees low. The vat reached 4.55 at hour eleven, and it stayed on hold for review: reaching the number late isn't the same as reaching it on time.

I read these sections on November 20, 2026. A rule published on October 13, 2026, and effective December 14, lets standardized foods use salt substitutes and updates the test methods the yogurt standard refers to. It leaves the pasteurization and pH requirements as they are. This is general information, not legal advice. How a food safety plan differs from classic HACCP is in preventive control plan vs HACCP, and a sister plan for cheese in cheese HACCP plan.

Get the worksheet

Download the yogurt HACCP plan worksheet. Three sheets and a read-me: the hazard analysis from raw milk to delivery, the plan with its three control points, and a monitoring log that checks each reading against its limit. It's an ordinary Excel file with no macros, and it works in Google Sheets, LibreOffice and Numbers.

Where this stops working

The plan lives in a binder, the chart on the pasteurizer, the pH readings on a clipboard, and the fruit certificates in an email folder. Then a shop phones about a cup of honey almond with a best-by of December 9, and you need all four for one vat: which milk, which fruit lot, what the chart said, what the pH was. On paper that's an afternoon, if every sheet was filed.

How TaroStack does it

TaroStack keeps the vat as one record.

Each vat is a batch. Recording it takes the milk, culture and fruit from stock and notes which lots went in, automatically.

Your readings are fields on the batch record. Hold temperature, start and end times, pH and the hour it was reached, initials, and a sign-off. The form prints with your own checklist.

A batch on hold stays out of what you can sell until someone releases it.

Allergens on Growth. With allergen tracking on, a batch can't start if its label leaves out an allergen its ingredients contain. The almonds are caught before the vat is filled.

One report for a recall. Which fruit lot went into which vats, which customers got them, and what's still in the cooler.

The job Binder and clipboard In TaroStack
Which milk and fruit went into YG-1117 Find the batch sheet On the batch record
The vat's pH and hold temperature A clipboard, a chart Fields on the batch
Keeping a held vat off the truck A sign on the cooler door On hold: not for sale
Who got that fruit lot Go through invoices One report

TaroStack doesn't write your plan, set a limit or take a reading. Recipes, batches, lots and recalls are on every plan, from $9.99 a month (5 recipes) or $39 a month (50 recipes, with allergen tracking). The first 14 days are free, with no credit card. If you'd like a hand setting up, ask, and we'll do it with you.

Questions people also ask

What are the critical control points for yogurt?

Pasteurizing the milk before the culture is added, fermenting to pH 4.6 or lower, and labeling, because of allergens. Cleaning after the pasteurizer is a sanitation control.

What temperature is milk pasteurized at for yogurt?

The legal minimum is 145°F for 30 minutes or 161°F for 15 seconds, 5°F higher if the mix is sweetened or 10% fat or more. Most makers heat hotter for texture.

What pH should yogurt be?

4.6 or lower, measured on the finished product within 24 hours after filling, under the federal standard for yogurt.

Sources

  1. 21 CFR 131.200 (yogurt): dairy ingredients pasteurized before the culture is added; pH 4.6 or lower measured on the finished product within 24 hours after filling · read November 20, 2026
  2. Federal Register, 91 FR 65040 (Oct. 13, 2026): Use of Salt Substitutes to Reduce the Sodium Content in Standardized Foods; effective December 14, 2026 · read November 21, 2026
  3. 21 CFR 131.3(b) (pasteurized: 145°F for 30 minutes, 161°F for 15 seconds, 5°F higher at 10% fat or with added sweeteners) · read November 20, 2026
  4. 21 CFR 1240.61 (mandatory pasteurization of milk and milk products in final package form) · read November 20, 2026
  5. 21 CFR 117.126 (the written food safety plan) · read November 19, 2026

We use AI to help with the research for these articles. Every one is read, checked against its sources and edited by Koa before it's published. Spot a mistake? Tell us and we'll fix it and say so. How we write these.

Let’s get your stack in order.

Get TaroStack

Sign up now for your free 14 day trial. No credit card required.