A noodle is flour and water, sometimes egg, and what keeps it safe depends on which of three things you sell. Fresh noodles are moist enough for bacteria to grow, so they're kept at 41°F or below. Cooked noodles are a heat-treated plant food, which the FDA Food Code lists as needing temperature control, and the danger is in the cooling: 135°F to 70°F within two hours, to 41°F within six in all. Dried noodles are safe on a shelf only once they're dry enough, and "dry enough" is a number: a water activity you measure. All three share a fourth point, the label, because wheat and egg are allergens. A noodle maker selling to restaurants and shops generally needs this written down as a food safety plan. Below are the four points, the numbers behind them, and a worksheet.
The short version
- Fresh: 41°F or below from the cutter to the customer's fridge.
- Cooked: cooled to 70°F in 2 hours and 41°F in 6. Spread thin.
- Dried: measured, not judged. Set a water activity limit and test every batch.
- Egg noodles and egg-free noodles on one line: egg-free first, full clean after.
- Tell your customers how to store what you sell them. Print it on the case.
- TaroStack keeps each batch with its readings, its lots and its use-by. More below.
Which noodle needs what
| Product | Why | Control |
|---|---|---|
| Fresh, uncooked | Moist, near-neutral dough: growth is possible | 41°F or below; a short use-by |
| Cooked, chilled | Heat-treated plant food; spores survive boiling | Cool fast; 41°F or below |
| Dried | Too dry for growth, once it is | Water activity at or below your limit |
| Frozen | No growth while frozen | Kept frozen; thawed under refrigeration |
The Food Code sorts food by pH and water activity. A food that hasn't been heat treated and has a water activity below 0.88 doesn't need temperature control at any pH. Above 0.92, at a pH above 4.6, it needs either refrigeration or a product assessment showing it's safe without. Fresh noodle dough is on the wrong side of that line unless a laboratory says otherwise. What the measurement is and how it's taken is in water activity for food makers.
The four points
A made-up noodle maker selling fresh, cooked and dried noodles.
| CCP | Limit | Checked | If it's missed |
|---|---|---|---|
| 1 Cold holding (fresh and cooked) | 41°F or below | Cooler twice a day; one case on each route | Find the time; discard if unknown |
| 2 Cooling cooked noodles | 135°F to 70°F within 2 hours; to 41°F within 6 hours in all | Center of the deepest tray, at 2 and 6 hours | Discard |
| 3 Drying | Water activity 0.85 or below before packing (this maker's limit) | Meter, a sample from the slowest rack, each batch | Keep drying; retest. Never packed above the limit |
| 4 Labeling | Wheat on every pack; egg on egg noodles | First and last pack of each run | Hold and relabel |
Cooling is the dangerous one. Boiling kills ordinary bacteria and leaves the spores of Bacillus cereus alive. In a deep tub of warm, wet noodles they wake up, multiply and make a toxin that reheating doesn't destroy. So cooked noodles are rinsed or shocked in cold water, drained, tossed with a little oil, spread in trays no more than two inches deep, and put straight into the cooler. Probe the middle of the deepest tray. The schedule and a log are in cooling log template.
Drying has a slow corner. Noodles on the rack nearest the door, or in the middle of a full dryer, dry last. Test those. This maker's limit of 0.85 sits below the Food Code's 0.88 to leave room for the meter and the weather. A batch that feels dry and reads 0.90 isn't dry.
The label is an allergen control. Wheat is in everything. Egg is in some. A changeover from egg noodles to egg-free without a full clean puts egg in a pack that doesn't declare it, and that's a recall: see undeclared allergen recall. Run egg-free first, clean after egg, and check the first and last pack of every run against the batch sheet. A written program is in allergen control plan template.
Your customer's prep table
A noodle maker's plan ends at the delivery door, and the trouble often starts after it. Fresh noodles left out through a lunch service, cooked noodles held warm in a tub by the wok: your product, their kitchen. Two things help. Print the storage instruction and the use-by on the case, large: "Keep at 41°F or below." And put a lot code on every case, so that if something does go wrong you can say which batch it was and where the rest went.
A few days of readings
| When | Batch | Check | Reading | Limit | OK? |
|---|---|---|---|---|---|
| Nov 16, 8:30 AM | Cooler | Cold holding | 38°F | 41°F or below | Yes |
| Nov 16, 12:00 PM | CN-1116 cooked lo mein, tray 3 | Cooling, 2 hours | 67°F | 70°F or below | Yes |
| Nov 16, 4:00 PM | CN-1116 cooked lo mein, tray 3 | Cooling, 6 hours | 40°F | 41°F or below | Yes |
| Nov 17, 3:00 PM | DN-1115 dried egg noodles, rack 6 | Water activity | 0.88 | 0.85 or lower | NO: act |
| Nov 18, 7:10 AM | Route 1, last stop | Cold holding | 40°F | 41°F or below | Yes |
On the 17th, rack 6, the one nearest the door, was still at 0.88 after forty hours. It dried for six more and read 0.81. Rack 6 is now the rack that's tested on every batch.
A restaurant making noodles for its own tables is under its health department's code, not the federal rule for food facilities. Your state may use an older edition of the Food Code; FDA's adoption page showed 14 states on the 2022 edition when I read it. This is general information, not legal advice. How a food safety plan differs from HACCP is in preventive control plan vs HACCP, and how long each kind keeps in pasta shelf life.
Get the worksheet
Download the noodle HACCP plan worksheet. Three sheets and a read-me: the hazard analysis from flour to delivery, the plan with its four control points, and a monitoring log that checks each reading against its limit. It's an ordinary Excel file with no macros, and it works in Google Sheets, LibreOffice and Numbers.
Where this stops working
A restaurant phones on Thursday: two customers were ill after the lo mein on Tuesday. Which batch did they have? The route sheet says twelve cases went to them on Monday. The cooling log has three batches that weekend. Nothing joins a case on a truck to a tray in the log, so the answer is "one of these three", and all three are suspect.
How TaroStack does it
TaroStack joins the case to the batch.
Each batch has a lot code and a use-by. Recording it takes the flour and egg from stock and notes which lots went in, automatically. Case labels print with the lot and the date.
Readings are fields on the batch record. Cooling at two and six hours, water activity, the rack it came from, initials and a sign-off.
The soonest date ships first by default, and the lots picked are on the delivery note.
Allergens on Growth. With allergen tracking on, a batch can't start if its label leaves out an allergen its ingredients contain.
One report for a recall. Which customers got batch CN-1116, and what's still in the cooler. Starting a recall holds the rest.
| The job | Route sheets and a log | In TaroStack |
|---|---|---|
| Which batch a restaurant got | One of three | The lot on the delivery note |
| The batch's cooling readings | A clipboard, by date | Fields on the batch |
| Which flour went in | The receiving log | On the batch record |
| Who else got it | Go through the route sheets | One report |
TaroStack doesn't write your plan, set a limit or measure water activity. Recipes, batches, lots and recalls are on every plan, from $9.99 a month (5 recipes) or $39 a month (50 recipes, with allergen tracking). The first 14 days are free, with no credit card. If you'd like a hand setting up, ask, and we'll do it with you.
